Horizon Hobby HANGAR 9 OV-10 Bronco 30cc Manuel D'utilisation page 13

55. Secure the fl ap servo in the servo tray using the hardware
included with the servo. The output of the servo will face
toward the trailing edge of the wing. Make sure to prepare
the holes in the servo tray using thin CA before the servo is
installed.
56. Pull the fl ap and aileron servo leads through the wing. Make
sure to mark the leads so they can be easily identifi ed.
57. Center the fl ap servo. Place the servo arm on the servo so it
is perpendicular to the servo centerline. Remove any arms
that may interfere with the operation of the servo using side
cutters.
58. Attach the fl ap linkage to the servo arm using an M3 x 12
button head screw, M3 washer and M3 Lock nut. Use a 2mm
hex wrench and 5.5mm nut driver.
 The washer must be placed on the outside of the ball link,
opposite the servo arm. Omitting this could allow the ball
to pop out of the plastic ball link causing loss of control.
59. Adjust the linkage to achieve the mid fl ap position of 30˚.
Once set, secure the servo arm to the servo using the
hardware included with the servo.
OV-10 Bronco 30cc
60. Use the radio or servo tester to move the fl ap to the up fl ap
position. Use the travel settings in the radio to set the fl ap
position
61. Use the radio to move the fl ap to the full fl ap position of 80˚.
Use the travel settings in the radio to set the fl ap position
 When installing the remaining flap servos, attach the servo
arm perpendicular to the servo center line in the mid flap
position. The linkage must be adjusted when the servo is in
the up flap position so the flaps are aligned correctly in flight.
 Take care not to over-travel the servos, as there is a
mechanical limit for both up and down flap positions.
Overloading the servos against these limits will result
in damage to the servos or control surfaces.
 Repeat this section to install the
remaining flaps and flap servos.
13 EN