Abicor Binzel ATS-Rotor Mode D'emploi page 34

S4-Coupled:
S5-Rotor up:
S6-Rotor down:
S7-Position 1:
Maintenance Maintenance intervals:
advice
Maintenance schedule.
•
•
•
•
Figure 6
8
9
10
11
11.1 Guide flange
11.2 Guide bolt
11.3 Ball-bearing
Turn-off the compressed air-supply, so that the fork head can be moved manually. Move the fork head
down to the lower stop, slightly loosen the reed-contact and move it upwards until the LED is activated,
then move it back 1 mm and screw it tight. Re-check the switching distance of 1 mm.
Turn on the compressed air-supply, set the switching distance of the proximity switch to approx. 0.5 up
to 1 mm.
Turn off the compressed air supply (the rotor must be in the lower position). Set the switching distance
of the distance proximity switch to approx. 0.5 up to 1 mm.
The setting is carried out in position 1. Re-connect the compressed air supply, set the switching distance
of the proximity switch to approx 0.5 up to 1 mm.
Attention!
When carrying out any kind of maintenance work you must ensure that the ATS-ROTOR is turned
off. Should the installation be situated in a secure area, it is recommended that all devices in the
cell are turned off, as for preventing any uncontrolled operation.
Information!
For details of spare parts, please refer to your supplier.
once per week clean the device with clean/dry compressed air.
twice per month oil the curved profile cam shaft (8) with a brush.
twice per month clean any contamination in the area of the change-over station, proximity switches and
stop screws and check all pneumatic hoses.
after approx. 20,000 neck changes or every other 3 months check the guide bolt (11.2).
11.3
11.1 11.4
Curved profile cam shaft
Electr. sequence control (PCL)
Angle for PCL
Guide cassette compl.
11.5
10
11.6
9
11
11.2
13
11.4 Ring
11.5 Safety ring
11.6 Safety ring
13 Rotor
17 Short-stroke cylinder
18 Fork-head
19 Stroke cylinder, change-over station
8
19
18
17