Assa Abloy OneSystem 819N Notice De Montage page 72

Fig. 17 :
Install a door fitting
Typical installation of a
profile cylinder
Fig. 18 :
Install a profile cylinder
EN
72
Installing the profile cylinder
The lock must be installed in the door before the profile cylinder can be installed ("Installing the electric
multi-point lock 819N", page 64, "Accessories", page 78). The profile cylinder must match the door
leaf thickness and the door fitting and protrude at least 3 mm from the door fitting when the door is
complete.
Install the profile cylinder as described in the accompany instructions. The following installation steps are typical:
1 Place profile cylinder in the profile cylinder cut-out (Fig. 18).
2 Fix it in place with the cylinder fixing screw.
3 Test the key for ease of movement.
 You have installed the profile cylinder and can operate the lock with a key.
2.
2.
1.
2.
2.
6.
3.
4.
5.
4.
4.
1
1.
Installation