Assa Abloy OneSystem 819N Notice De Montage page 67

Fig. 11 :
Adjusting the latch
range of latch lock
807-10
!
Fig. 12 :
Adjusting the panic side
Installation
Optional: Adjust the latch range on latch lock 807-10
9 Adjust the latch bolt range on the optional latch lock 807-10 (Fig. 11).
< Ø3
Changing the panic side
The panic side of a lock with escape door function ("Escape door function/emergency exit and panic door
locks", page 45) must be adjusted before installation. The panic side of the lock must be adjusted so
that the door can be opened in the escape direction (normally outward from inside) with the door handle,
regardless of the locking status of the lock.
Warning!
An incorrectly adjusted panic side can result in life-threatening danger and risk of injury: After install-
ing the lock, check whether the locked door can be opened in the escape direction.
1. 2.
4.
6.
T8
3.
2,5 mm
5.
7.
Triggering self-locking
The locking screws are always located on the
panic side.
1 Press and hold the latch bolt (Fig. 12).
2 Press the control latch.
3 Release the latch bolt while pressing the
control latch.
 The deadbolt is eliminated.
Adjust the panic side
4 Unscrew the locking screw.
5 Re-insert the locking screw on the opposite
side (torque 2.5 Nm).
6 Unscrew the locking screw.
7 Re-insert the locking screw on the opposite
side (torque 2.5 Nm).
 The panic function is now set on the opposite
lock side.
 Check the panic function using a latchkey and
a spindle (9 mm) before installing the lock.
EN
67