Troubleshooting Table - Scheppach HS410 Traduction Du Manuel D'origine

Warning: In the interests of operational safety, always switch off the saw and remove the mains plug before carrying out main­
tenance work.
Problem Possible Cause
Saw blade gets loose Fastening nut tightened insufficiently
after turning off the
motor
Motor does not start a) Fastening nut tightened insufficiently
b) Extension cable defect
c) Connections on the motor or switch defect
No motor output turns Overload by dull saw blade, thermoprotection
off automatically is triggered
Burns on the cutting a) Fastening nut tightened insufficiently
surface b) Wrong saw blade
c) with longitudinal c) Longitudinal stop not parallel
cuts
d) with cross cuts d) Slide carriage not parallel

Troubleshooting table

Help
Tighten fastening nut, M20 left-handed
thread
a) Check the mains fuse.
b) See "Electrical Connection" in the
operating manual
c) Have it checked by an electrician
Insert a sharpened saw blade; motor can be
turned on again after the cooling period
a) Insert a sharpened saw blade
b) Insert saw blade with 20 or 28 teeth for
longitudinal cuts
c) Exchange the longitudinal stop
Align the slide carriage with the saw blade
39