Troubleshooting - Scheppach HS110 Traduction Des Instructions D'origine

17. Troubleshooting

Fault Possible cause
1. Blade dissolves To slightly tightened fastening nut
after switching off
the engine
2. Engine will not a) Failure mains fuse
start
b) Defective extension cable
c) Connections on motor or switch not
in order
d) Motor or switch faulty
3. Motor wrong direc- a) Capacitor faulty
tion of rotation
4. Motor will not work, a) Cross section of the extension cable
the fuse is activ does not suficiently
b) Overload by a blunt saw blade
5. Fire marks on the a) blunt saw blade
cutting surface
b) wrong saw blade
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Possible cause
Tighten the right hand thread nut
a) Check mains fuse
b) Replace extension cord
c) Repair by electrical specialist
d) Repair by electrical specialist
a) Repair by electrical specialist
a) see „Electrical connection"
b) Change saw blade
a) Sharpen or change saw blade
b) Change saw blade
GB | 41