Disposal And Recycling; Transport; Troubleshooting - Scheppach HBS30 Traduction Des Instructions D'origine

13. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled.
The equipment and its accessories are made of vari-
ous types of material, such as metal and plastic. De-
fective components must be disposed of as special
waste. Ask your dealer or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can
occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical
and electronic equipment.

15. Troubleshooting

Fault Possible cause
Motor does not work Motor, cable or plug defective,
fuses burnt
Housing cover open (limit switch)
The motor starts up Voltage too low, coils damaged,
slowly and does not capacitor burnt
reach operating speed.
Motor makes excessive Coils damaged, motor defective
noise
The motor does not Circuits in the network are over-
reach its full power. loaded (lamps other motors, etc.)
Motor overheats easily. Overloading of the motor, insuf-
ficient cooling of the motor
Saw cut is rough or wavy Saw blade dull, tooth shape not
appropriate for the material thick-
ness
Workpiece pulls away Excessive cutting pressure and/or
and/or splinters saw blade not suitable for use
Saw blade is not running Guide has been wrongly set
straight
Wrong saw blade
Burn marks appear on Blunt saw blade
the wood during the cut- Wrong saw blade
ting work
Saw blade jams during Blunt saw blade
cutting work Deposits on the saw blade
Guide has been set poorly
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Improper handling of waste equipment may have
negative consequences for the environment and hu-
man health due to potentially hazardous substances
that are often contained in electrical and electronic
equipment. By properly disposing of this product, you
are also contributing to the effective use of natu-
ral resources. You can obtain information on collec-
tion points for waste equipment from your municipal
administration, public waste disposal authority, an
authorised body for the disposal of waste electri-
cal and electronic equipment or your waste disposal
company.

14. Transport

The machine must only be lifted and transported on
its frame or the frame plate. Never lift the machine at
the safety devices, the adjusting levers, or the saw-
ing table.
During the transport the saw blade protection must
be in the lowest position and near the table.
Never raise at the table! Unplug the machine from the
mains during transport.
Remedy
Arrange for inspection of the machine by a specialist.
Never repair the motor yourself. Danger! Check fuses
and replace if necessary
Close housing cover exactly
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a specialist.
Arrange for replacement of the capacitor by a specialist
Arrange for inspection of the motor by a specialist
Do not use any other equipment or motors on the same
circuit
Avoid overloading the motor while cutting, remove dust
from the motor in order to ensure optimal cooling of the
motor
Resharpen saw blade and/or use suitable saw blade
Insert suitable saw blade
Set the saw blade guide according to the operating
instructions
Select a saw blade according to the operating instruc-
tions
Change the saw blade
Select a saw blade according to the operating instruc-
tions
Change the saw blade
Clean the saw blade
Set the saw blade guide according to the operating
instructions
GB | 31