Disposal And Recycling - Scheppach HS110 Traduction Des Instructions D'origine

• If the network conditions are unfavourable, the de-
vice may result in temporary voltage luctuations.
• The product is intended for use only on premises
which have a mains continuous current rating of at
least 100 A per phase and are supplied by a distri-
bution network with a rated voltage of 230V.
• As the user, you must ensure – in consultation with
your electricity supply company if necessary – that
the continuous current carrying capacity of the net-
work at the connection point to the public mains is
suficient for the connection of the product.
Important Instructions
If the motor is overloaded, it switches itself off auto-
matically. After cooling down (times vary), the motor
can be switched on again.
Faulty Electrical Connection Cable
Insulation damage often occurs to electrical connec-
tion cables.
The causes of this may be as follows:
• Pressure points if connection cables are routed
through windows or door gaps.
• Kinks caused by improper attachment or routing of
the connection cable.
• Cut surfaces caused by vehicles driving over the
connection cable.
• Insulation damage caused by tearing out of the wall
socket.
• Cracks resulting from the insulation becoming old.
Such faulty electrical connections must not be used
and may endanger life due to the damage to the in-
sulation.
Electrical connection cables should be checked reg-
ularly for damage. Ensure that during such checks,
the connection cable is not connected to the mains.
Electrical connection cables must comply with the
relevant VDE and DIN regulations. Only use connec-
tion cables with the marking H05VV-F.
It is stipulated by law that the type of connection cable
must be printed on it.
Alternating Current Motor
The mains voltage must be 230 V~.
Extension cables up to 25 m in length must have a
cross-section of 1.5 mm².
Connections and repairs to the electrical equipment
may only be performed by a qualiied electrician.
If you have any queries, please provide the following
information:
• Current type of the engine
• Data from the machine type plate
• Data from the motor type plate

16. Disposal and recycling

40 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
The equipment is supplied in packaging to prevent it
from being damaged in transit.
The raw materials in this packaging can be reused
or recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Do not throw batteries away with house-
hold waste, or throw them into fire or water. Batteries
should be collected and recycled or disposed of in
an environmentally friendly manner. Defective com-
ponents must be disposed of as special waste. Ask
your dealer or your local council!
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can
occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical
and electronic equipment. Improper handling of waste
equipment may have negative consequences for the
environment and human health due to potentially
hazardous substances that are often contained in
electrical and electronic equipment. By properly dis-
posing of this product, you are also contributing to the
effective use of natural resources. You can obtain in-
formation on collection points for waste equipment
from your municipal administration, public waste dis-
posal authority, an authorised body for the disposal of
waste electrical and electronic equipment or your
waste disposal company.