Disposal And Recycling; Troubleshooting - Scheppach PL55 Traduction Des Instructions D'origine

14. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective com-
ponents must be disposed of as special waste. Ask
your dealer or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
disposed of at a designated collection point.

15. Troubleshooting

Problem
The motor does not run.
The motor starts slowly
and does not reach run-
ning speed.
Excessive motor noise.
The motor does not reach
full power.
Motor overheats easily
Decrease in cutting
power when sawing
The saw cut is rough or
wavy
The work piece rips or
splinters
34 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Possible Cause
Faulty motor, power supply cable or
plug. Burned out fuses.
Low power supply voltage. Damaged
windings. Burned out capacitor.
Damaged windings. Faulty motor.
Overloaded circuit due to lighting,
utilities or other motors.
Overload of the motor; inadequate
cooling of the motor
The saw blade is too small (sharp-
ened too often)
The saw blade is dull; the tooth shape
is not suited to the thickness of the
material
The cutting pressure is excessive or
the saw blade is not suited to the ap-
plication
This can occur, for example, by handing it in at an
authorised collecting point for the recycling of waste
electrical and electronic equipment. Improper han-
dling of waste equipment may have negative conse-
quences for the environment and human health due
to potentially hazardous substances that are often
contained in electrical and electronic equipment. By
properly disposing of this product, you are also con-
tributing to the effective use of natural resources. You
can obtain information on collection points for waste
equipment from your municipal administration, public
waste disposal authority, an authorised body for the
disposal of waste electrical and electronic equipment
or your waste disposal company.
Help
Have the machine checked by skilled personnel.
Do not try to repair the machine yourselves as it
may be dangerous. Check the fuses and replace
them if necessary.
Ask for the Electricity Board to check the voltage
available. Have the machine motor checked by
skilled personnel. Have the capacitor replaced by
skilled personnel.
Have the motor checked by skilled personnel.
Do not use other utilities or motors on the circuit to
which the track saw is connected.
Prevent overloading the motor when cutting;
remove dust from the motor to ensure an optimum
cooling of the motor
Re-adjust the end stop of the saw unit
Re-sharpen the saw blade or use an appropriate
saw blade
Use the correct saw blade