Troubleshooting - Scheppach MBS1100 Traduction Des Instructions D'origine

14. Troubleshooting

Problem
Motor does not work
The motor starts up slowly
and does not reach oper-
ating speed.
Motor makes excessive
noise
The motor does not reach
its full power.
Motor overheats easily.
Saw cut is rough or wavy
Workpiece pulls away
and/or splinters
Saw blade is not running
straight
Burn marks appear on the
wood during the cutting
work
Saw blade jams during
cutting work
30 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Possible cause
Motor, cable or plug defective, fuses
burnt
Voltage too low, coils damaged, capaci-
tor burnt
Coils damaged, motor defective
Circuits in the network are overloaded
(lamps, other motors, etc.)
Overloading of the motor, insufficient
cooling of the motor
Saw blade dull, tooth shape not appro-
priate for the material thickness
Excessive cutting pressure and/or saw
blade not suitable for use
• Guide has been wrongly set
• Wrong saw blade
• Blunt saw blade
• Wrong saw blade
• Blunt saw blade
• Deposits on the saw blade
• Guide has been set poorly
Help
Arrange for inspection of the machine by a spe-
cialist. Never repair the motor yourself. Danger!
Check fuses and replace as necessary
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a specialist.
Arrange for replacement of the capacitor by a
specialist
Arrange for inspection of the motor by a specialist
Do not use any other equipment or motors on the
same circuit
Avoid overloading the motor while cutting, remove
dust from the motor in order to ensure optimal
cooling of the motor
Resharpen saw blade and/or use suitable saw
blade
Insert suitable saw blade
• Set the saw blade guide according to the oper-
ating instructions
• Select a saw blade according to the operating
instructions
• Change the saw blade
• Select a saw blade according to the operating
instructions
• Change the saw blade
• Clean the saw blade
• Set the saw blade guide according to the oper-
ating instructions