Enabling Or Disabling Ramp-Up And Ramp-Down Times; Program Lock - Hettich Rotina 420 R Mode D'emploi

7.6.5

Enabling or disabling ramp-up and ramp-down times

7.6.6

Program lock

AB4701en
[START] button.
3. Press the
'SOUND / BELL = on' or 'SOUND / BELL = off' is displayed.
��
[PROG] button repeatedly until 'Dual time mode enabled' or
4. Press the
'Dual time mode disabled' is displayed.
[Rotary knob] to set 'enabled' or 'disabled' .
5. Use
disabled = The function is disabled
enabled = The function is enabled.
[START] button.
6. Press the
�� The settings are stored.
'Store Settings...' is displayed briefly.
'-> Settings' is then displayed.
[STOP/OPEN] button once to exit the 'Settings' menu
7. Press the
or
[STOP/OPEN] button twice to exit the '***Machine Menu***' .
Press the
The rotor is stationary.
1. Press and hold the
'***Machine Menu***' is displayed after 8 seconds.
��
[PROG] button repeatedly until '-> Settings' is displayed.
2. Press the
[START] button.
3. Press the
'SOUND / BELL = on' or 'SOUND / BELL = off' is displayed.
��
[PROG] button repeatedly until 'Ramp Unit = Steps' or
4. Press the
'Ramp Unit = Steps / Time' is displayed.
[Rotary knob] to set 'Steps' or 'Steps / Time' .
5. Use
Steps = ramp-up and ramp-down times disabled,
Steps / Time = ramp-up and ramp-down times enabled.
6. Press the [START] button.
�� The setting is stored.
'Store Settings...' is displayed briefly.
'-> Settings' is then displayed.
7. Press the [STOP/OPEN] button once to exit the 'Settings' menu
or
[STOP/OPEN] button twice to exit the '***Machine Menu***' .
Press the
The following program locks can be set when the rotor is at a standstill:
Rev.: 19 / 02.2025
[PROG] button.
Software operation
47 / 64