25
Activating/deactivating the "Dual time mode" function"
The "Dual time mode" function can be activated and deactivated as follows when the rotor is at a standstill:
You can scroll backwards through the menu by pressing the
The operation can be cancelled at any time by pressing the
stored.
Keep the
key held down for 8 seconds.
PROG
After 8 seconds, Machine Menu appears in the display.
Press the
key as often as necessary until the ->Settings is displayed.
PROG
Press the
key. The SOUND / BELL = off/on is displayed.
START
Press the
key until Dual time mode enabled/disabled is displayed.
PROG
Use the knob
to set enabled or disabled.
disabled = The function is deactivated,
enabled = The function is activated.
Press the
key to save the setting.
START
Briefly, Store Settings ... is displayed as confirmation, followed by -> Settings.
Press the
key once to exit the "Settings" menu or press the
OPEN / STOP
"Machine Menu".
26
Activate or deactivate B-braking stages
The B-braking stages can be activated or deactivated as follows when the rotor is at a standstill.
You can scroll backwards through the menu by pressing the
The operation can be cancelled at any time by pressing the
stored.
Keep the
key held down for 8 seconds.
PROG
After 8 seconds, Machine Menu appears in the display.
Press the
key as often as necessary until the ->Settings is displayed.
PROG
Press the
key. The SOUND / BELL = off/on is displayed.
START
Press the
key as often as is required until B-Ramp = off/on is displayed.
PROG
Use the adjusting knob to set
off = B-braking stages are deactivated,
on = B-braking stages are activated.
Press the
key to save the setting.
START
Briefly, Store Settings .. is displayed as confirmation, followed by -> Settings.
Press the
key once to exit the "Settings" menu or press the
OPEN / STOP
"Machine Menu".
27
Activating or deactivating start-up and run-down times
The start-up and run-down times can be activated or deactivated as follows with the rotor at a standstill:
You can scroll backwards through the menu by pressing the
The operation can be cancelled at any time by pressing the
stored.
Keep the
key held down for 8 seconds.
PROG
After 8 seconds, Machine Menu appears in the display.
Press the
key as often as necessary until the ->Settings is displayed.
PROG
Press the
key. The SOUND / BELL = off/on is displayed.
START
Press the
key as often as is required until Ramp Unit = Steps / Steps / Time is displayed.
PROG
Use the adjusting knob to set
Steps = start-up and run-down times deactivated,
Steps / Time = start-up and run-down times activated.
Press the
key to save the setting.
START
Briefly, Store Settings .. is displayed as confirmation, followed by -> Settings.
Press the
key once to exit the "Settings" menu or press the
OPEN / STOP
"Machine Menu".
AB5650DEENFRIT
off or on.
Steps or Steps / Time.
Rev. 16 / 04.2020
key.
T/°C
key. In this case, the settings are not
OPEN / STOP
key twice to exit the
OPEN / STOP
key.
T/°C
key. In this case, the settings are not
OPEN / STOP
key twice to exit the
OPEN / STOP
key.
T/°C
key. In this case, the settings are not
OPEN / STOP
key twice to exit the
OPEN / STOP
EN
81/220