Opening A Program Link; Enabling Or Disabling Program Links; Cleaning And Care; Overview Table - Hettich Rotina 420 R Mode D'emploi

7.7.2

Opening a program link

7.7.3

Enabling or disabling program links

8

Cleaning and care

8.1

Overview table

Chap. Task to execute
8 Cleaning and care
8.3 Cleaning
8.3 Cleaning the device
8.3 Cleaning biosafety systems
AB4701en
[START] button.
10. Press the
'STO B' is displayed.
��
[START] button to save the program link.
11. Press the
'Multi program store...' is displayed briefly.
��
1. Press the [PROG] button repeatedly until 'RCL A...Z' is displayed.
[Rotary knob] to set the desired program location.
2. Use the
[START] button.
3. Press the
'Multi program recall...' is displayed briefly.
��
The centrifugation data of the first program of the program link is
displayed, along with the total runtime of the program link.
1. Press and hold the
'***Machine Menu***' is displayed after 8 seconds.
��
[PROG] button repeatedly until '-> Settings' is displayed.
2. Press the
[START] button.
3. Press the
'SOUND / BELL = off' or 'SOUND / BELL = on' is displayed.
��
4. Press the [PROG] button repeatedly until ' Multi programs = off' or
' Multi programs = on' is displayed.
[Rotary knob] to set 'off' or 'on' .
5. Use
off = program link disabled
on = program link enabled
[START] button.
6. Press the
�� The setting is stored.
'Store Settings...' is displayed briefly.
'-> Settings' is then displayed.
[STOP/OPEN] button once to exit the 'Settings' menu
7. Press the
or
[STOP/OPEN] button twice to exit the 'Machine Menu' .
Press the
Rev.: 19 / 02.2025
[PROG] button.
X
Cleaning and care
53
55
55
X 55
53 / 64