Disposal; General Instructions - Hettich Rotina 420 R Mode D'emploi

10

Disposal

10.1

General instructions

AB4701en
Fig. 26: Automatic circuit breaker
1 Plastic pin
The mains switch is in switch position
The centrifuge is disconnected from the mains.
1. Press the plastic pin (
2. Reconnect the device to the mains.
The device can be disposed of via the manufacturer.
A Return Material Authorisation (RMA) form must always be
requested for a return.
If necessary, contact the Technical Service Department of
the manufacturer:
−
Andreas Hettich GmbH
−
Föhrenstraße 12
−
78532 Tuttlingen, Germany
−
Phone: +49 7461 705 1400
−
E-Mail: service@hettichlab.com
WARNING
Risk of soiling and contamination
Damage to the environment and health due to improper
disposal.
−
Observe national and local environmental protection and
disposal regulations to ensure proper disposal or recy-
cling. Separate metals, non-metals, composite materials
and auxiliary materials by type and dispose of them in an
eco-friendly manner.
−
The device may only be disassembled and disposed of
by trained and authorised service technicians.
The device is intended for the commercial sector ("Business to Business" -
B2B).
According to Directive 2012/19/EU, the devices may no longer be disposed
of with household waste.
The devices are assigned to the following groups according to the Stiftung
Elektro-Altgeräte Register (EAR (German foundation under civil law)):
Rev.: 19 / 02.2025
[O]
1 ) of the automatic circuit breaker.
Disposal
1
61 / 64