Activating Or Deactivating Start-Up And Run-Down Times; Acoustic Signal - Hettich ROTANTA 460 Robotic Mode D'emploi

26

Activating or deactivating start-up and run-down times

The start-up and run-down times can be activated or deactivated as follows with the rotor at a standstill:
This setting can only be made via the operating unit (key position "0" or "LOCK 2"). The functions of the
various key positions are described in the "Key-operated switch" chapter.
You can scroll backwards through the menu by pressing the
The operation can be cancelled at any time by pressing the
stored.
• Keep the key held down for 8 seconds.
PROG
After 8 seconds, ∗∗∗ Machine Menu ∗∗∗ appears in the display.
• Press the key as often as necessary until the ->Settings is displayed.
PROG
• Press the key. The SOUND / BELL = off/on is displayed.
START
• Press the key as often as is required until Ramp Unit = Steps / Steps / Time is displayed.
PROG
• Use the adjusting knob to set
Steps = start-up and run-down times deactivated,
Steps / Time = start-up and run-down times activated.
• Press the key to save the setting.
START
Briefly, Store Settings .. is displayed as confirmation, followed by -> Settings .
• Press the key once to exit the "Settings" menu or press the
OPEN / STOP
"Machine Menu".
27

Acoustic signal

The acoustic signal sounds:
• After a disturbance occurs, in 2 second intervals.
•
After completion of a centrifugation run and rotor standstill in 30 second intervals.
The acoustic signal is stopped by opening the lid or pressing any key.
The acoustical signal can be activated or deactivated as follows when the rotor is at a standstill:
This setting can only be made via the operating unit (key position "0" or "LOCK 2"). The functions of the
various key positions are described in the "Key-operated switch" chapter.
You can scroll backwards through the menu by pressing the
The operation can be cancelled at any time by pressing the
stored.
• Keep the key held down for 8 seconds.
PROG
After 8 seconds, ∗∗∗ Machine Menu ∗∗∗ appears in the display.
•
Press the key as often as necessary until the ->Settings is displayed.
PROG
• Press the key. The SOUND / BELL = off/on is displayed.
START
SOUND / BELL : Signal after the centrifugation run ends.
• Use the adjusting knob
•
Press the key. The SOUND / BELL error = off/on is displayed.
PROG
SOUND / BELL error : Signal after a disturbance occurs.
•
Use the adjusting knob
•
Press the key to save the setting.
START
Briefly, Store Settings ... is displayed as confirmation, followed by -> Settings .
• Press the key once to exit the "Settings" menu or press the
OPEN / STOP
"Machine Menu".
AB5680DEENFRIT
Steps or Steps / Time .
to set off or on .
to set off or on .
Rev. 12 / 04.2020
key.
T/°C
key. In this case, the settings are not
OPEN / STOP
key twice to exit the
OPEN / STOP
key.
T/°C
key. In this case, the settings are not
OPEN / STOP
key twice to exit the
OPEN / STOP
EN
81/179