Stihl RMI 632 Manuel D'utilisation page 168

Message:
1030 – Hood fault
Check hood
Then press OK
Possible cause:
– No hood detected
Remedy:
– Check hood (movement, firm seating)
and confirm the message with OK
Message:
1100 – Control panel
Control panel removed during travelling
Possible cause:
– Control panel has been removed during
automatic operation
Remedy:
– Confirm the message with OK –
automatic operation resumes once the
control panel has been inserted
Message:
1120 – Hood blocked
Check hood
Then press OK
Possible cause:
– Permanent collision detected
Remedy:
– Free the robotic mower, remove the
obstacle or change routing of perimeter
wire if necessary – then confirm the
message with OK
– Check movement of the hood and
confirm the message with OK
166
Message:
1125 – Remove obstacle
Check wire routing
Possible cause:
– Perimeter wire routed inaccurately
Remedy:
– Check the routing of the perimeter wire;
check the clearances with the
iMow Ruler ( 12.5)
Message:
1130 – Stuck
Free iMow
Then press OK
Possible cause:
– Robotic mower has become stuck
– Drive wheels are spinning
Remedy:
– Free the robotic mower, level out the
mowing area or change routing of
perimeter wire if necessary – then
confirm the message with OK
– Clean the drive wheels, if necessary
prevent operation during rain – then
confirm the message with OK (
Message:
1131 – Stuck
On level surfaces:
Deactivate ASM
Possible cause:
– ASM also activated on a level surface
Remedy:
– Deactivate ASM on level surfaces
( 11.14)
Message:
1135 – Outside
Place iMow in mowing area
Possible cause:
– The robotic mower is located outside
the mowing area
Remedy:
– Return the robotic mower to the mowing
area
Message:
1140 – Too steep
Check wire routing
Possible cause:
– Tilt sensor has detected slope
inclination exceeding 22°
Remedy:
– Change routing of perimeter wire, block
off lawns with slope inclinations
exceeding 22°
Message:
1160 – Handle actuated
Press OK to release
11.12)
Possible cause:
– The robotic mower has been lifted by
the carry handle
Remedy:
– Confirm message with OK
Message:
1170 – No signal
Switch on docking station
Possible cause:
– Docking station is switched off
– No reception of wire signal during
operation
– The robotic mower is located outside
the mowing area
0478 131 9942 C - EN