Programming The Robotic Mower - Stihl RMI 632 Manuel D'utilisation

● Check the position of the robotic mower
before continuing edge following. The
machine must either be located on the
perimeter wire or within the mowing
area with the front facing the perimeter
wire.
Continuation following interruption:
After an interruption, continue edge
following with Yes.
No ends following of the perimeter wire
and the next step of the installation
assistant is called up.
Recommendation:
Do not cancel edge following.
Possible problems when following
the edge of the mowing area or
when docking may not be
recognised.
Edge following can be repeated
following initial installation if
necessary. ( 11.14)
The robotic mower docks after one
complete circuit around the mowing area.
Then a second edge-following run is
started in the opposite direction.
0478 131 9942 C - EN
Automatic completion of edge
following:
The next step of the installation assistant is
called up when the robotic mower docks
following the second complete circuit.

9.14 Programming the robotic mower

Enter the size of the lawn and
confirm with OK.
Installed no-go areas and
secondary areas must not be
included when calculating the size
of the mowing area.
A new mowing plan is calculated.
The procedure can be aborted using the
red STOP button on the top of the
machine.
Confirm the message "Confirm each
day individually or change active
time" by pressing the OK button.
The active times for Monday are
displayed and the menu item
Confirm active times is enabled.
All the active times are confirmed
with OK and the next daily plan is
displayed.
In the case of small mowing areas,
not all the week days are used for
mowing. In this case, no active
times are displayed and the menu
item "Delete all active times" is
omitted. Days without active times
must also be confirmed with OK.
125