Adapting The Programming - Stihl RMI 632 Manuel D'utilisation

Lift the rear of the control panel (1) with a
slight tug and remove it from the robotic
mower. It remains connected to the
machine via a spiral cable.
0478 131 9942 C - EN
Inserting the control panel:
Stow the spiral cable (1) in the housing
compartment. Tilt the control panel
rearwards slightly, insert the retainers (2)
in the recesses in the housing (3), then
press down the control panel at the front
and allow to engage.

15.3 Adapting the programming

Current programmes can be seen in the
mowing plan or, in the case of the
RMI 632 C, RMI 632 PC models, in the
iMow app. ( 11.6)
The mowing plan is calculated based on
the size of the mowing area during
installation or during the creation of a new
mowing plan.
The active times and the mowing
duration can be changed individually, the
required mowing operations themselves
are automatically distributed over the
possible active times. If required, several
mowing or charging operations can run
during an active time. If required, the edge
of the mowing area can be cut
automatically at regular intervals.
( 11.14)
Up to three different active times per day
are possible. ( 11.6)
If the robotic mower has to travel to
specific areas of the mowing area, starting
points must be defined. ( 11.15)
Under certain circumstances
(e.g. warm weather or generous
time window), not all the active
times may be necessary for optimal
lawn care.
Changing the active times: (
– Additional active times for further
mowing operations.
– Adapting the time window in order, for
example, to prevent mowing during the
morning or night.
– Omitting individual active times
because the mowing area is e.g. being
used for a party.
Extending the mowing duration: (
– There are areas which are not mown
sufficiently, e.g. because the mowing
area has lots of corners.
– Intensive grass growth during the
growing period.
– Particularly dense lawn.
11.7)
11.8)
151