9.4 Installation material
If the perimeter wire is not routed by the
specialist dealer, additional installation
material not included in the standard
equipment will be required to be able to
operate the robotic mower. (
The installation kits contain perimeter wire
on a reel (1) as well as fixing pins (2) and
wire connectors (3). The standard
equipment in the installation kits may
include additional parts not required for the
installation.
9.5 Installing the battery
Lithium-ion batteries must be
treated with particular care. STIHL
recommends that you have the
battery installed by a STIHL
specialist dealer. A defective
battery must only be replaced by a
STIHL specialist dealer.
The battery remains permanently
installed in the robotic mower,
removal is only necessary prior to
disposal of the machine. (
0478 131 9942 C - EN
● Set the lowest cutting height (level 1).
(
9.6)
● Place the robotic mower on its back on
a suitable surface.
18.)
Insert the battery (C) as shown and allow it
to engage.
20.1)
Fit the cover (F) and tighten the
screws (G). Observe a maximum
tightening torque of 1 - 2 Nm.
● Set the robotic mower on its wheels.
9.6 Adjusting the cutting height
Set the cutting height to at least
level 5 in the first weeks (until the
grass has grown over the perimeter
wire) to prevent the perimeter wire
being damaged and to guarantee
reliable operation.
Levels 1, 2, 3 and 4 are special
heights for very level lawns (ground
unevenness < +/- 1 cm).
Lowest cutting height:
Level 1 (20 mm)
Highest cutting height:
Level 8 (60 mm)
113