Storage And Winter Break - Stihl RMI 632 Manuel D'utilisation

1 Fold open the left clamping lever (1).
2 Remove wire end (2) from the terminal
block and then close clamping lever again.
● Open the panel and fit the docking
station cover. ( 9.2)
The following instructions describe how to
search for a wire break in a clockwise
direction, i.e. the perimeter wire is followed
in a clockwise direction starting at the
docking station. If necessary, the search
can also be carried out anti-clockwise, but
in this case the right wire end must be
removed from the terminal block.
● Remove the control panel if necessary.
( 15.2)
● In the "Service" menu, select the "Find
wire break" entry and confirm OK.
( 11.17)
158
Searching with the control panel
removed:
Starting at the docking station, follow the
edge of the mowing area clockwise with
the robotic mower (1). Steer the machine
using the control pad for this purpose and
ensure that the perimeter wire (2) runs
under the wire sensor. The wire sensors
are installed in a protected position on the
left and right at the front of the robotic
mower.
During the wire break search, the signal
strength is indicated on the display; the
wire sensors are in the ideal position
above the perimeter wire when this value
is at its highest.
The Wire signal OK symbol
appears on the display when
the wire sensors are correctly
receiving the wire signal.
In the area of the wire break, the
signal strength drops and the
Check wire signal symbol
appears on the display.
● Bridge the break with the aid of a wire
connector ( 12.16). If necessary, re-
route the perimeter wire in the area of
the break.
● Reconnect the left wire end. (
● Once the wire break has been correctly
rectified, the red LED illuminates.
( 13.1)
Fine search with the control panel
inserted:
Lift the robotic mower slightly by the
carrying handle (1) and relieve the weight
on the drive wheels. Push the machine,
resting on its front wheels, and follow the
perimeter wire (2).
The further procedure corresponds to the
search with the control panel removed.

16.8 Storage and winter break

Note the following points when storing the
robotic mower (e.g. winter break,
temporary storage)):
● Charge the battery ( 15.8)
● Switch off automatic mowing (
0478 131 9942 C - EN
9.11)
11.5)