Stihl RMI 632 Manuel D'utilisation page 169

Masquer les pouces Voir aussi pour RMI 632:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

– Docking station or electronic
components were replaced
Remedy:
– Switch on docking station and give
mowing command
– Check power supply to the docking
station
– Check LED on the docking station – the
red LED must be permanently
illuminated during operation (
– Return robotic mower to the mowing
area
– Link robotic mower and docking station
(
11.16)
Message:
1180 – Dock iMow
Automatic docking
not possible
Possible cause:
– The docking station was not found
– The start or end of a corridor was
installed incorrectly
Remedy:
– Check the LED on the docking station,
switch on the docking station if
necessary (
13.1)
– Check docking (
15.7)
– Check funnel-shaped entrance and exit
areas of the corridor (
12.11)
Message:
1190 – Docking error
Docking station occupied
Possible cause:
– Docking station occupied by a second
robotic mower
Remedy:
– Dock the robotic mower once the
docking station is unoccupied again
0478 131 9942 C - EN
Message:
1200 – Mowing motor fault
see message 0505
Message:
1210 – Drive motor fault
Wheel stuck
Possible cause:
13.1)
– Overload at a drive wheel
Remedy:
– Clean the robotic mower (
– Level out any uneven areas (holes,
depressions) in the mowing area
Message:
1220 – Rain detected
Mowing interrupted
Possible cause:
– Mowing operation has been interrupted
or not started due to rain
Remedy:
– No action necessary; adjust rain sensor
if required (
Message:
1230 – Docking error
Dock iMow
Possible cause:
– Docking station has been located,
automatic docking not possible
Remedy:
– Check docking, if necessary manually
dock robotic mower (
– Check perimeter wire – ensure correct
routing in the area of the docking station
(
9.10)
16.2)
11.12)
15.7)
Message:
2000 – Signal problem
Dock iMow
Possible cause:
– Wire signal faulty, fine tuning necessary
Remedy:
– Place the robotic mower in the docking
station – then press OK
Message:
2010 – Replace mowing blade
Allowed operating time reached
Possible cause:
– Mowing blade has been in use for more
than 200 hours, replacement is
necessary
Remedy:
– Replace the mowing blade, then
confirm the blade replacement in the
"Service" menu (
16.4)
Message:
2020 – Recommendation
Annual service by spec. dealer required
Possible cause:
– Machine service recommended
Remedy:
– Have the annual service carried out by
a STIHL specialist dealer
Message:
2030 – Battery
Allowed operating time reached
Possible cause:
– Battery replacement necessary
Remedy:
– Have the battery replaced by a STIHL
specialist dealer
167

Hide quick links:

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Rmi 632 pRmi 632 cRmi 632 pcRmi 422 pRmi 422 pcRmi 422

Table des Matières