Corridors - Stihl RMI 632 Manuel D'utilisation

The docking station (1) is installed in the
mowing area A, which is cut fully
automatically in accordance with the
mowing plan.
The secondary areas B and C are
connected to the mowing area A via the
linking sections (2). The perimeter wire
must be routed in the same direction in all
areas – do not cross perimeter wires in the
linking areas.
● Activate secondary areas in the
"Settings – Installation" menu.
( 11.14)

12.11 Corridors

If several mowing areas have to be mown
(e.g. mowing areas in front of and behind
the house), these can be linked by
installing a corridor. This allows all the
mowing areas to be mown automatically.
144
In corridors, the lawn is only mown
along the path of the perimeter
wire. If necessary, activate
automatic edge mowing or mow the
corridor area manually on a regular
basis. ( 11.5), ( 11.14)
If corridors are to be installed,
switch off offset drive home
(passage) ( 11.14) or install guide
loops. ( 12.12)
The specified wire clearances and
the corridor template are adapted to
the routing of the perimeter wire on
the lawn area. The dimensions will
deviate if the perimeter wire is
routed very deeply, e.g. under
stone paving. Check the function
and adapt the wire routing if
necessary.
Requirements:
– Minimum width (space requirement):
between solid obstacles: 108 cm
between paths that can be travelled on:
27 cm.
In longer corridors, a slightly
increased space requirement
should be taken into account
depending on the ground
conditions. Longer corridors should
always be installed as centrally as
possible between obstacles.
– The corridor can be travelled on freely.
– At least 1 starting point must be
defined in the area of the second
mowing area. ( 11.15)
The docking station (1) is installed in
mowing area A. Mowing area B is linked
to mowing area A by means of a
corridor (2). The perimeter wire (3) can be
continuously followed by the robotic
mower. In order to mow mowing area B,
starting points (4) must be defined.
( 11.15)
Individual mowing operations can then be
started at the starting points, depending on
the setting (starting frequency).
Start and end of the corridor:
0478 131 9942 C - EN