Installing The Docking Station - Stihl RMI 632 Manuel D'utilisation

Confirm your language selection
with the OK button or select
"Change" and repeat the language
selection.
● If necessary, enter the 9-digit serial
number of the robotic mower. This
number is printed on the identification
plate (sticker in compartment under
control panel).
Set the current date using the
control pad and confirm with the OK
button.
0478 131 9942 C - EN
Set the current time using the
control pad and confirm with the OK
button.

9.9 Installing the docking station

Read the "Notes on the docking
station" section ( 9.1) and study
the installation examples (
this instruction manual.
● Connect the power cable to the docking
station. ( 9.2)
● Route the power cable under the floor
plate when the docking station is
installed at a wall. ( 9.1)
Fix the docking station (B) into position at
the chosen location using four pegs (H).
● Install the power supply unit outside the
mowing area, protected from direct
27.) in
sunlight, humidity and moisture – fasten
to a wall if necessary.
Correct operation of the power
supply unit is only ensured at an
ambient temperature between
0° C and 40° C.
● Route all power cables outside the
mowing area, in particular out of reach
of the mowing blade, and fasten them to
the ground or accommodate in a cable
duct.
● Unreel power cables in the vicinity of
the docking station in order to avoid
interference with the wire signal.
● Connect the mains plug.
The red LED on the docking station
flashes rapidly as long as no
perimeter wire is connected.
( 13.1)
115