Stihl RMI 632 Manuel D'utilisation page 124

1 Fold open the right clamping lever (1).
2 Insert the stripped wire end (2) into the
terminal block as far as it will go.
3 Close the clamping lever (1).
Check the seating of the wire ends in the
terminal block: the two wire ends must be
firmly fastened.
● Close the panel. ( 9.2)
122
Close the cover of the cable duct (1).
● After completing this installation
work, press the OK button on the
control panel.
Install the cover. ( 9.2)
Then press the OK button on the
control panel.
Connect the power supply unit plug
to the mains, then press the OK
button.
When the perimeter wire is correctly
installed and the docking station is
connected to the mains power supply, the
LED (1) illuminates.
Observe the "Docking station
controls" section, particularly if the
LED does not illuminate as
described. ( 13.1)
0478 131 9942 C - EN