REBER 9600 N Notice D'utilisation Et Entretien page 38

When changing the accessories, please follow carefully the installation instructions
supplied with the machine.
The machine is prepared for putting into practice:
-Remove the cap (7) rotating it counterclockwise.
-Fill in the tank (8) according to the quantities and ingredients mentioned in the
paragraph called Recipes and Advice for Usage.
-Place the cap (7) on the tank (8) (rotate the cap in such a way in order to fasten it,
and rotate clockwise and block it at the end in order to allow the putting into
practice of the machine.
-During the functioning, if necessary, liquid or flour may be added through the slots
of the cap (7) without turning off the machine.
-After a period of functioning of approximately 2,5/3 min., if the dough is well mixed
(if it isn't you may continue with the functioning) turn off the dough machine, rotate
the cap (7) counterclockwise in order to dismantle it and remove the dough. If you
have observed the dosages mentioned in the Recipes and Advice for Usage
paragraph, the dough must be compact and can be easily removed from the tank
(8). The dough may be at this point manipulated in order to give it a specific form
or it may be cut in order to be used in cutter for Reber pasta which you can
assemble on the same engine by replacing the dough machine in order to make
spaghetti or one of the 11 types of pasta.
-Once you have finished the job, rotate de mixer (9) counterclockwise in order to
remove it from the base, rotate the tank in the same direction (8) and dismantle it
from the base, wash and perfectly dry all the accessories.
-The cap (7) and the tank (8) are made of food grade plastic material and they can
be washed in the dish-washer taking into account the fact that very aggressive
detergents or very high cleaning temperatures may damage the esthetic features
of the product, but not their technical features.
-The mixer (9) is made of corrosion proof steel AISI 316 and may be washed in the
dish-washer taking into account the fact that very aggressive detergents or very
high cleaning temperatures may damage the esthetic features of the product, but
not their technical features.
-Once you have cleaned the components, fit on the tank (8) on the base (rotate the
cap in order to fit it on ), rotating clockwise and block it until the end (the first times
the tank shall be swung over in order to fix it properly), place the mixer at the end
(9) and block it on the drive pin slots rotating it clockwise, secure the cap on the
tank (rotate the cap in order to secure it ), rotate clockwise. We advise you not to
block it until the end of the fitting in order to avoid damaging the safety switch .
38