Using The Appliance - REBER 9600 N Notice D'utilisation Et Entretien

TECHNICAL DATA ART. 9602 N – V 230/50 Hz : 9656 N – V 240/50 Hz : 9657 N
- V 115/60 Hz
Single-phase asynchronous electric motor for continuous service 600 W. Gear
switch forward/reverse to use only in case of block of the meat mincer attachment;
do not use reverse function with other attachments to avoid risks of injury. Fan
cover cap, switch/capacitor box and cooling fan made in plastic material.
Watertight IP X5 motorization. Axial reduction gear in oil bath. Long-life oil suitable
for occasional food contact.
TECHNICAL DATA ART. 9603 N – V 230/50 Hz : 9659 N – V 240/50 Hz : 9658
N - V 115/60 Hz
Single-phase asynchronous electric motor for continuous service 1200 W. Gear
switch forward/reverse to use only in case of block of the meat mincer attachment;
do not use reverse function with other attachments to avoid risks of injury ( no
forward/reverse for 9658N UL-CSA model). Fan cover cap, switch/capacitor box
and cooling fan made in plastic material. Watertight IP X5 motorization. Axial
reduction gear in oil bath. Long-life oil suitable for occasional food contact.

USING THE APPLIANCE

Before operating the machine, the user must remove the red cap (5A) from the
reduction gear and replace it with the cap with bleed and seal, located in a bag,
taking care that the bleed hole is turned upward. The machine must definitely not
be started without replacing the red cap with the bleeder cap. The geared motor is
supplied as standard with the right amount of oil necessary for its proper operation.
It is a long-life oil suitable for occasional food contact, it is not subject to
deterioration or consumption due to machine operation, and must NOT be
replaced. Any topping up should only be done with the same type of oil if there has
been visible and substantial leakage. The reduction gear contains 40 grams ( only
art. 9600 N – V 230/50 Hz : 9650 N – V 240/50 Hz : 9651 N - V 115/60 Hz) other
models 80 grams of oil and any excess after topping up will be expelled from the
bleed hole during operation.
To operate, the appliance must be connected to a power point that is always easily
accessible during use. All operations not specified in this manual must be done by
a qualified operator. The machine must be located on a plain surface and positions
which can produce the falling of the machine must be avoided.
TOMATO SQUEEZER UNIT
Tomato squeezer propeller made in acetal resin suitable for food contact, body in
cast iron tested for foodstuffs and treated with epoxy paint for foodstuffs. Nylon tow
35