Fitting The Printout To The Paper; Adjusting The Color Balance - Sony UP-55MD Mode D'emploi

To eliminate a horizontal black line produced at
the bottom:
Adjust the bottom position of the image to be
printed using the V WIDTH item.
When a vertical black line is produced on
the printout
To eliminate a vertical black line produced on
the left side:
Adjust the left position of the image to be printed
using the H START item.
Note
It is alright if a black line appears on the right side
while you adjusting on the left side. You can
eliminate it using the H WIDTH item.
To eliminate a vertical black line produced on
the right side:
Adjust the right position of the image to be printed
using the H WIDTH item.
To reset the values to defaults
For H START, H WIDTH, V START and V
WIDTH items, you can reset the values to defaults
in pairs.
To reset the values for vertical settings, position the
cursor at either V START or V WIDTH, and then
press the G and g buttons simultaneously.
To reset the values for horizontal settings, position
the cursor at either H START or H WIDTH, and
then press the G and g buttons simultaneously.
H WIDTH H START
Defaults NTSC/PAL:
680
To check the adjustment result
Print to check that no black frame appears on the
printout, that the image is not partially cut, and that no
black line appears.

Fitting the Printout to the Paper

1
Display the WINDOW SETUP menu from the
LAYOUT SETUP menu.
V WIDTH V START
NTSC/PAL: NTSC:464, NTSC/PAL:
0 PAL: 560 0
2
Select RESIZE TO FIT.
Highlight RESIZE TO FIT in green.
When you want to
Print the image with the printout
area adjusted on the WINDOW
SETUP menu
Print the adjusted image to fit to the
paper

Adjusting the Color Balance

You should use the ink ribbon and paper that are
contained in the same package as a pair. The color
balance may differ depending on each pair.
It is recommended that you adjust the color balance each
time you load a new set of ink ribbon and paper.
Before adjusting the color balance
Reset all items on the COLOR ADJUST menu to
defaults. (See "Adjusting the Printout Color" on page
53.)
1
Display the COLOR BALANCE menu from the
PRINTER SETUP menu.
Select C-BALANCE, then press the g button.
Adjusting the Color and Picture Quality
Setting
OFF
ON
57