Sony UP-55MD Mode D'emploi page 58

The highlighted area on the COLOR BALANCE
menu will be printed to be used for adjusting the
color balance.
You can move this area to any place on the video
monitor.
The area that will be captured in memory.
(This area is highlighted and is two third the
size of the whole screen.)
When you adjust the color balance for the first time
after you purchase the printer, the values of BAL X,
BAL Y and BAL STEP are set to 50, 50 and 05 at
the factory setting.
When you have adjusted the color balance already,
the values adjusted previously are displayed on the
COLOR BALANCE menu.
The currently adjusted values of BAL X, BAL Y and
BAL STEP
On this COLOR BALANCE menu, the default values
(factory settings) are displayed.
To reset the values to the factory setting
(50/50/05)
Select each item by pressing the F or f button, then
press the G and g buttons at the same time. The
currently selected item is reset to the default.
58
Adjusting the Color and Picture Quality
2
Decide the position of the source image to be used
for adjusting the color balance.
To decide the position of the source image, move
the highlighted area by pressing the F, f, G or g
button while holding down the DISPLAY button.
Move the highlighted part to the desired image
position by pressing the F, f, G or g button while
holding down the DISPLAY button. (The COLOR
BALANCE menu disappears temporarily.)
3
Press the CAPTURE button.
The image captured in memory appears.
4
Select TEST PRINT by pressing the F or f button,
then press the EXEC button.
Nine identical images of the position selected in
step 2 are printed on a sheet of paper as a test print.
Each image has a different color balance.