Sony UP-55MD Mode D'emploi page 15

1
Open the front door by pulling the front door
toward you.
2
Remove the ink ribbon cartridge.
If you can not remove the ink ribbon
cartridge
The thermal head may be out of position.
In such a case, close the front door, and turn the
power off, then back on again. After a while, start
the operation from step 1 again.
3
Detach the spent ink ribbon from the ink ribbon
holder.
Pushing the ink ribbon spool that takes up the ink
ribbon in the direction of the arrow, remove the
spool from the side with the gray gear.
Pushing the ink ribbon spool that sends the ink
ribbon in the direction of the arrow, remove the
spool from the side with the white gear.
4
Load the new ink ribbon into the ink ribbon holder.
1 Holding the ink ribbon firmly, remove the gear
cover.
Gear cover
To avoid dropping the ink ribbon, make
sure that you hold it firmly.
15
Before Printing