Setting Date And Time - Sony UP-55MD Mode D'emploi

2 Select the type of the input signal.
Highlight the desired input signal in green
by pressing the G or g button.
Signal input to the RGB/
YCbCr/SYNC INPUT
connectors
RGB input signal
YCbCr input signal
The format of the component signal output from the
RGB/YCbCr/SYNC OUTPUT connector depends
on the component signal selected here.
5
Press the MENU button.
The normal screen appears.

Setting Date and Time

The printer adds a time stamp when the captured image
data is stored on an external USB flash memory device.
Also, you can make a printout with the date when the
image was printed. To put the correct time stamp or to
print the correct printing date on printouts, you have to
set the correct date and time.
Note
The factory-installed battery is for monitoring.
If date and time display lags, the battery may be drained.
Please contact your Sony service facility or your Sony
dealer.
20
Before Printing
Select
1
RGB
2
YCbCr
3
2, 4
2, 7
2, 3
1
4, 5
Turn on the video monitor and the printer.
Press the MENU button and display the LAYOUT
SETUP menu by pressing the F, f, G or g button.
Switch LAY to green by pressing the F, f, G or g button,
then the LAYOUT SETUP menu appears.
Select CLOCK ADJUST by pressing the F or f
button.
Highlight CLOCK ADJUST in green by
pressing the F or f button.
6