Connecting The Video Monitor - Sony UP-55MD Mode D'emploi

to wall outlet
AC power cord
(not supplied)
to AC IN
to VIDEO
INPUT
to S
Connecting
VIDEO
cable (with
INPUT
DIN 4-pin
connectors)
75-ohm
coaxial cable
with BNC
to S VIDEO
connectors
output
connector
to composite
video output
connector
Video equipment
a) Two kinds of 75 Ω termination switches are provided, one
is for the RGB/YCbCr input and the other is for the
composite video signal. Normally set this switch to ON.
Set it to OFF if the level of the input signal drops because
the signal is divided to additional video equipment other
than the printer.
b) Set the dip switches to match your video signal system.
Set the switch 1 to the lower position to set the video signal
system to NTSC. Set the switch 1 to upper position to set
the video signal system to PAL. To switch the video signal
system, turn the power off once, then change the setting.
Then, turn the power on again. If you change the setting
with the power on, this mode will not be switched.
c) When YCbCr signal is input, it is not necessary to connect
to the SYNC connector.r.

Connecting the Video Monitor

Connect a video monitor to view captured images and to
check those to be printed. Connect a suitable video
monitor which will be used in actual printing, using the
following diagram as a guide.
75-ohm
termination
a)
switch
b)
Dip switch
to RGB/YCbCr/
c)
SYNC INPUT
75-ohm
coaxial cable
with BNC
connectors
to RGB/
YCbCr output
connectors
to wall outlet
AC power cord
(not supplied)
to AC IN
to VIDEO
OUTPUT
to S VIDEO
Connecting
OUTPUT
cable (with
DIN 4-pin
connectors)
75-ohm
coaxial cable
to S VIDEO
with BNC
input
connectors
connector
to composite
video input
connector
Video monitor
a) Set the dip switches to match your video signal system
Set the switch 1 to the lower position to set the video
signal system to NTSC. Set the switch 1 to upper
position to set the video signal system to PAL. To switch
the video signal system, turn the power off once, then
change the setting. If you change the setting with the
power on, this mode will not be switched.
b) When connecting the video monitor only to the RGB/
YCbCr/SYNC OUTPUT connector without connecting
to SYNC connector, set OUTPUT SYNC in the
OUTPUT SETUP menu to ON.
c) When YCbCr signal is output, it is not necessary to
connect to the SYNC connector.
a)
Dip switch
to RGB/YCbCr/
b)
SYNC OUTPUT
75-ohm
coaxial cable
with BNC
connectors
to RGB/YCbCr
input
c)
connectors
13
Connections