Connecting The Video Monitor - Sony UP-20 MD Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Connecting the Video Monitor

Connect a video monitor to view captured images and to
check those to be printed. Connect a suitable video
monitor which will be used in actual printing, using the
following diagram as a guide.
Before connecting the video equipment, see "Important
safeguards/notices for use in the medical environments"
on page 2.
When connecting the video monitor only to the
RGB OUTPUT connectors (only for the UP-
21MD)
When connecting the video monitor only to the RGB
OUTPUT connector without connecting to SYNC
connector, set SYNC ON G in the OUTPUT SETUP
menu to ON.
a)
NTSC/PAL selector
AC power cord
UP-21MD
to RGB SYNC
to S VIDEO
b)
OUTPUT
OUTPUT
75-ohm coaxial
cable with BNC
connectors
to S VIDEO
input
to RGB input
connector
connectors
a) Set the NTSC/PAL selector to match your TV system. To
switch the TV system, turn the power off once, then change
the setting. If you change the setting with the power on, this
mode will not be switched.
b) See "When connecting the video monitor only to the RGB
OUTPUT connectors (only for the UP-21MD)".
to wall outlet
(supplied)
to AC IN
to VIDEO
INPUT
Connecting
cable (with
DIN 4-pin
connectors)
75-ohm
coaxial cable
with BNC
connectors
to composite
video input
connector
Video monitor
15
Connections

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Up-21 md

Table des Matières