Sony UP-55MD Mode D'emploi page 9

the DISPLAY item in the OUTPUT SETUP menu.
The setting of DISPLAY in the OUTPUT SETUP
menu changes linked with the press of this button.
When the menu is displayed, pressing this button
temporarily clears the menu display. While this
button is held down, the menu display disappears.
F MENU button
Press this button to display or clear the menus.
G F/f/G/g (Cursor) keys
Use to select a desired item from the menu.
Also, these keys are used to position the cursor
(green pointer) on the regular screen when
capturing multiple reduced images.
H CLEAR button (41, 42)
Press this button to clear the images captured in the
memory pages. Which images can be cleared with
the CLEAR button depends on the setting made
with the FUNCTION SETUP menu.
When the clear function of this button is set to OFF,
the buzzer sounds if you press the CLEAR button.
I EXEC button
Press this button to execute the values set with the
COLOR ADJUST menu or to load a user set in the
PRINTER SETUP menu and to register the user set
in the SYSTEM SETUP menu. Also, this button is
used to enter the characters of a caption in the
CAPTION menu.
J LOAD USER button
Press this button to recall a registered user set.
K
MULTI PICTURE button (31)
Press this button to select the desired printout type
on the regular screen. When you press this button,
the currently selected printout type is displayed for
a few seconds. Each time you press this button, the
type is switched in the following sequence: 1, 2, 4,
8, 1.... The setting of MULTI PIX on the LAYOUT
SETUP menu changes linked with the press of this
button.
L
PRINT QTY (quantity) button (26)
Press this button to set the number of copies on the
regular screen. You can set any number up to 10.
When you press this button, the currently selected
number is displayed for a few seconds. The setting
of PRINT QTY on the PRINTER SETUP menu
changes linked with the press of this button. You
can change the number of copies currently printed
even when the printer is printing.
M
CAPTURE button
Press this button to capture an image in a memory
page.
N
PRINT button
Press this button to make a printout.
O USB host port
Insert the USB flash memory into this port.
Note
Be sure not to insert a USB flash memory
manufactured by other manufactures other than
Sony Corporation.
P x STOP button (23)
Press this button to stop continuous printing. The
printer stops printing after finishing the printing
item currently being printed.
Q
SOURCE/MEMORY button
Press this button to select which signal is to be
output to the monitor.
The memory image and source image are toggled
each time you press this button.
R
MEMORY PAGE button (28, 31, 42)
Press to select the memory page.
S Paper output slot
Printed pages (printouts) are ejected here.
Depending on the curled condition of printouts, the
printer may stop printing and display the message
"REMOVE PRINTS." In such a case, remove the
printouts accumulated on the paper tray. The printer
will start to print the remaining copies
automatically.
T Paper tray (12, 17)
Load paper into this tray.
U ! POWER switch
Press this switch to turn the printer on or off.
Location and Function of Parts and Controls
9