Rohloff E-14 SPEEDHUB 500/14 Notice Originale page 64

Wheel installation
Joining together of the external gear mech:
Method 1:
Remove cable box and turn the twist shifter into gear #1. Refit cable box and shift until
it can no longer be turned. If you are not in gear #14 of the twist shifter then disconnect
the cable box and turn the twist shifter into gear #14.
Now reconnect the cable box to have access to all 14 gears.
Rejoining the gear mech involves remounting the
cable box. Place the twist shifter into gear #14 then
place cable box E over the hexagonal peg I, so that
the two locating pegs H sit into the two holes in the
back of the cable box.
Turn the twist shifter back and forth around gear
#14 until the cable box falls into place over the hex-
agonal peg. Lastly tighten up the knurled head
screw.
ATTENTION
Should all 14 gears not be selectable after fitting the
cable box, it will be down to the hub or the twist
shifter not being in gear #14. There are two meth-
ods to correct this.
Method 2:
Remove the cable box and turn the twist shifter into
gear #14. Take an 8mm wrench and use it to turn
the hexagonal peg on the external transfer box an-
ticlockwise until it reaches the end stop. Now the
hub is in gear #14, so the cable box can be re-
mounted.
64