Rohloff E-14 SPEEDHUB 500/14 Notice Originale page 61

61
Wheel installation OEM version
Wheel installation OEM2 versions
After installing the wheel, secure the wheel in position using the correct tightening
torque. CC axles with security skewer = 7Nm. TS axles = 35Nm. A12 securing bolts =
20Nm or evenly tighten the screws alternately and gradually (A12 version 15-20Nm).
On the OEM or OEM2 versions, the axle and the
torque support are installed together.
On the OEM versions, the axle must enter the long
OEM dropout first, followed by the support block into
the same slot.
On the OEM2 versions with the Rohloff Monkey
Bone, take care that the Rohloff Monkey Bone sup-
port point lines up with the axle plate seat as the
axle is entered into the dropouts.
On the OEM2 versions with just a support, take care
that the support bolt lines up with the axle plate seat
is emtered into the dropouts.
Wheel installation