Rohloff E-14 SPEEDHUB 500/14 Notice Originale page 59

59
Wheel installation
Please take note of the following steps when mounting the wheel to the frame:
1. Installation of the wheel into the frame
2. Securing the axle and torque arm (where appropriate)
3. Joining of the gear mech
Wheel installation
Place the wheel into the dropouts, taking care that the chain / belt is sitting properly on
the sprocket and that the hub cables do not get clamped between the dropouts and
the axle. Ensure the electrical cables of E-14 versions do not get „trapped or clamped"
ATTENTION
A chain tensioner prevents the easy installation of
the rear wheel (when mounted). The chain ten-
sioner must be pulled backwards in the direction of
the arrow to allow the sprocket to pass the chain
tensioner. When, however, it is a DH chain ten-
sioner, then the mounting bolt must be loosened be-
fore the rear wheel can be installed.
Wheel installation