Rohloff E-14 SPEEDHUB 500/14 Notice Originale page 58

Wheel removal
Loosening the torque support on versions with a long torque arm
CC versions (for quick release axle)
TS versions (axle nut M10x1mm)
Removal of the wheel from the frame
Open the quick release F by pushing the locking pin
G from the inside of the frame in an outward direc-
tion away from the wheel.
Open the axle quick release lever.
Pull the torque arm down in the direction of the ar-
row to release it from the frame.
Loosen the torque arm clamp bolt by unscrewing it
with a 4mm allen key
Loosen the axle nuts with a 15mm wrench.
Remove the wheel from the dropouts and the chain
from the sprocket.
ATTENTION
A chain tensioner prevents the easy removal of the
rear wheel (when mounted). The chain tensioner
must be pulled backwards in the direction of the ar-
row to allow the sprocket to pass the chain ten-
sioner. When, however, it is a DH chain tensioner,
the mounting bolt must be loosened before the rear
wheel can be removed.
58