Rohloff E-14 SPEEDHUB 500/14 Notice Originale page 62

Wheel installation
Wheel installation - PM Axleplate with PM Bone
Pay close attention to the orientation of the PM axleplate, to ensure the forked head
grips correctly around the PM Bone support peg once installed.
Secure the wheel in position using the correct tightening torque once the wheel is back
in the frame. CC axles with security skewer = 7Nm. TS axles = 35Nm. A12 securing
bolts = 20Nm.
ATTENTION
Check that both sides of the axle sit properly in the dropouts and that the wheel rotates
freely in the center of the frame before closing the quick release lever, tightening the
axle nuts or the A12 securing bolts.
Wheel installation on versions with a long torque arm
Securing the torque arm CC versions (for quick release axle)
Pay close attention to the orientation of the PM ax-
leplate, to ensure the forked head grips correctly
around the PM Bone support peg once installed.
When reinstalling PM SPEEDHUB versions, ensure
that the supporting peg of the PM Bone lines up with
the axleplate seat as the SPEEDHUB is inserted
into the dropouts.
Swing the torque arm into the quick release block in
the direction of the arrow shown.
62