Table des Matières
Publicité
How to install your Allegro®
Wall Security Strap
The Allegro Wall Security Strap is designed to mount on walls with standard wood framing. If you have a different type of wall
construction (brick, concrete, etc.), it may require a different fastener. Check with your local hardware store or contractor.
Parts included
» 1 adjustable belt strap
» 1 3 1/2" eye-fastener
Tools you will need
» Drill with 1/8" bit (not included)
» Phillips or flathead screwdriver (not included)
INSTALL THE EYE-FASTENER
1. Find a stud in the wall where you would like to stand your
Allegro. Make sure you have ample space on both sides of
the stud as well as above for the Allegro. Using a 1/8" drill bit,
pre-drill a hole into the stud. The hole should be positioned 5'
to 5 1/2' above the floor. Secure the eye-fastener into the pre-
drilled hole with the screwdriver until the shaft of the fastener
is completely within the wall.
USING THE WALL SECURITY STRAP
2. Follow your Allegro or
Allegro Tower instructions
for proper standing
procedure.
3. Move the Allegro against
the wall with the footbar
pointed away from the wall
or perpendicular to the
wall.
4. Wrap the strap ends
around one rail and
connect the ends like a
belt, using the adjustable
clip.
NOTE: Do not try to wrap the strap ends around the entire frame
– it will not fit. Pull the slack on the strap to tighten.
IMPORTANT: Balanced Body is not responsible for any damage or
injury caused by improper wall mount installation, or the use of
incorrect or improper wall mounting equipment.
If you have any questions, please call Balanced Body at
1-800-PILATES (1-800-745-2837) in the U.S. and Canada, or
+1-916-388-2838 (international).
23
Publicité
Table des Matières
