Balanced Body Allegro Mode D'emploi page 12

INSTALL THE SHOULDER RESTS
1. Remove the locking pins on each side of the headrest. Note
the two protruding studs on the bottom of the shoulder rests.
Lower the shoulder rest studs into the keyholes and slide away
from the carriage pad.
Fig A
Insert the locking pin through the hole in the shoulder rest and
the hole in the carriage to lock the shoulder rests. See Figure A.
Note: The shoulder rests can be installed in the two positions.
One position is wider, and more comfortable for broad shoulders.
Swap the left and right shoulder rests to change between
standard and wide configurations.
Figure B shows the storage position for the shoulder rests. note
the key hole slots at the head end of the Allegro frame.
Fig B
12
INSTALL THE BLACK PLUNGER KNOBS
2. Screw the plunger knob into the large hole until it is
completely threaded through the trunnion plate. If the plunger
knob does not screw easily into the threaded hole, use the
supplied open end wrench to screw it in. Do NOT use pliers.
See Figure C.
Repeat on other side. Tighten
both plunger knobs securely
with the included open end
wrench.
Note: Make sure both trunnion
plates are in the same
horizontal position before
trying to install the plunger
knobs.
INSTALL THE FOOTBAR
3. This step will be easier if you have someone help you. One
person should hold the weight of the footbar while the other
guides the footbar into position.
Position the footbar so the seam of the footbar cover is away
from the carriage pad.
Pick up the footbar. While
squeezing the footbar spring
pin handles, guide the footbar
over the outsides of the
trunnion plates. Align each
footbar spring pin with vertical
footbar adjustment hole 1.
While continuing to support
the footbar, slowly release the
footbar spring pin handles to
allow the spring pins to engage
hole #1 on the trunnion plate.
Be sure the pins on both sides
are engaged. See Figure D.
4. Pivot the footbar slightly until the large hole at the bottom
of the footbar aligns with the remaining hole in the trunnion
plate.
5. Slide the shoulder bolt with two washers through the large
footbar hole. Then screw the shoulder bolt into the trunnion
plate as tightly as possible with the large allen wrench. Repeat
on the other side. See Figure D.
Note: As you tighten the bolts, wiggle the footbar slightly. This will
make it easier to tighten the bolts securely.
Trunnion
Plate
Plunger
Knob
Figure C
Plunger Pin Lever Vertical footbar
adjustment
hole #1
Washer
Trunion Plate
Shoulder Bolt
Fig D