Labeling The Module; Connecting The Bus Coupler Electrically - Aventics SERCOS III Mode D'emploi

62 AVENTICS | SERCOS III | R412012610–BDL–001–AB
Assembly
Bus coupler
6.2

Labeling the module

O
Inscribe the address provided/used for the bus coupler on
the bus coupler in the BTN field.
Slide-in pockets for labels to identify the push-in fittings are
located on the housing (see "Spare parts and accessories" on
page 84).
Fig. 4: Label areas on the bus coupler
6.3

Connecting the bus coupler electrically

Applied voltage
Danger of injury from electric shocks.
O
Make sure the relevant system component is not under
voltage or pressure before electrically connecting
modules to the valve terminal.
CAUTION