Declaration Of Conformity; Seção - ESAB ESP-101 Manuel D'instruction

The Low Voltage Directive 2006/95/EC, The EMC Directive 2004/108/EC
Type of equipment
Plasma Cutting power source
Brand name or trade mark
ESAB
Type designation etc.
ESP 101 – (0558005215)
Manufacturer positioned outside the EEA:
Name, address, telephone No, telefax No:
ESAB Welding & Cutting Products
411 South Ebenezer Road, Florence, South Carolina 29501, USA
Phone: +1 843 669 4411, Fax: +1 843 664 4258
Manufacture's authorised representative established within the EEA
Name, address, telephone No, telefax No:
ESAB AB
Esabvägen, SE-695 81 Laxå, Sweden
Phone: +46 586 81000, Fax: +46 584 411 924
The following harmonised standard in force within the EEA has been used in the design:
EN 60974-1, Arc welding equipment – Part 1: Welding power sources
EN 60974-10, Arc welding equipment – Part 10: Electromagnetic compatibility (EMC) requirements
Additional information: Restrictive use, Class A equipment, intended for use in locations other than residential
By signing this document, the undersigned declares as manufacturer, or the manufacturer's authorised
representative established within the EEA, that the equipment in question complies with the safety requirements
stated above.
Date / Datum
Laxå 2009-09-03

DECLARATION OF CONFORMITY

According to
Signature / Underskrift
Kent Eimbrodt
Clarification
2
Position / Befattning
Global Director
Equipment and Automation