Memorisation Of Radio Transmitters - Nice AVIO600 Instructions Et Avertissements Pour L'installation Et L'utilisation

84
Photocell
Internal photocell h= 50 cm;
A
activated when closing
Internal photocell h= 100 cm;
B
activated when closing
External photocell h= 50 cm;
C
activated when closing and
opening
External photocell h= 100 cm;
D
activated when closing and
opening
WARNING: in the AVIO600/1000 version it has a maximum load of 6 units; a pair of photocells absorbs power equal to 1 ECSBus.
5.4 – FULL DELETION OF THE CENTRAL MEMORY (NO
RADIO CODES)
When full deletion of the memory is required, to restore the default set-
tings, perform the following procedure with the motor stationary:
1 Press and hold buttons P2 and P3 simultaneously
2 When all the LEDs light up simultaneously, release the buttons (after
roughly 5 seconds)
3 Once the procedure terminates, LED L1 flashes.
86
PR P3
WARNING: after full deletion, rerun the device acquisition and
position learning procedure.
5.5 – MEMORISATION OF RADIO TRANSMITTERS
The control unit contains a radio receiver for transmitters ECCO5...; the
transmitter contained in the package is already memorised and working.
If you wish to memorise a new radio transmitter you have two choices:
85
TABLE 12
Jumpers Photocell
E
F
G
• Mode 1: in this "mode" the radio transmitter is used to its fullest extent,
i.e. all the buttons execute a pre-established command. It is obvious that
in Mode 1 a radio transmitter can be used to command a single automa-
tion, i.e.:
Button T1
Button T2
Button T3
Button T4
ButtonT5
• Mode 2: one of the four commands available can be associated to
each button. This mode, used properly, allows you to command 2 or
more different automations; for example:
Button T1
P1
Button T2
Button T3
Button T4
Obviously, each transmitter is a separate unit, and while some are memo-
rised in mode 1 others can be memorised in mode 2 on the control unit.
The overall memory capacity is 150 units; memorisation in mode 1 takes up
one unit for each transmitter while mode 2 takes up one unit for each button.
Warning: since the memorisation procedures are timed (10s), you
must read the instructions in the following paragraphs before you
proceed with their execution.
External photocell activated
when opening
Internal photocell activated
when opening
Opening command photocell
(cut the jumper on the rear of
the TX and RX boards)
"Step-by-Step" command (SbS)
"Open partially" command
"Open only" command
"Close only" command
"Courtesy lightON/OFF" command
"Open only" command automation N° 1
"Close only" command automation N° 1
"Step-by-Step" (SbS) command automation N° 2
"Step-by-Step" (SbS) command automation N° 3
Jumpers
English – 19