Nice AVIO600 Instructions Et Avertissements Pour L'installation Et L'utilisation page 53

EU Declaration of Conformity and declaration of incorporation of "partly completed machinery"
Note - The contents of this declaration correspond to declarations in the official document deposited at the registered offices of Nice S.p.a. and in
particular to the last revision available before printing this manual. The text herein has been re-edited for editorial purposes. A copy of the original
declaration can be requested from Nice S.p.a. (TV) I.
Number: 582/AVIO
Manufaturer's Name:
Address:
Authorized Person to constituite
techinical documentation:
Type of products:
Model/Type:
Accessories:
he undersigned Roberto Griffa, in the role of Chief Executive Officer, declares under his sole responsibility that
the product described above complies with the provisions laid down in the following directives:
• Directive 2014/30/EU (EMC), according to the following harmonized standards: EN 61000-6-2:2005, EN
61000-6-3:2007+A1:2011
The product also complies with the following directives according to the requirements envisaged for "partly
completed machinery" (Annex II, part 1, section B):
• Directive 2006/42/EC of the EUROPEAN PARLIAMENT AND COUNCIL of 17 May 2006 related to machinery
and amending the Directive 95/16/EC (recast).
It is hereby stated that the relevant technical documentation has been compiled in accordance with annex VII B
of Directive 2006/42/EC and that the following essential requirements have been fulfilled: 1.1.1 - 1.1.2 - 1.1.3
- 1.2.1 - 1.2.6 - 1.5.1 - 1.5.2 - 1.5.5 - 1.5.6 - 1.5.7- 1.5.8 - 1.5.10 - 1.5.11
The manufacturer undertakes to transmit to the national authorities, in response to a reasoned request, the
relevant information on the " partly completed machinery ", while maintaining full rights to the related intellectual
property.
Should the " partly completed machinery" be put into service in a European country with an official language
other than that used in this declaration, the importer is obliged to arrange for the relative translation to accom-
pany this declaration.
The "partly completed machinery" must not be used until the final machine in which it is incorporated is in turn
declared as compliant, if applicable, with the provisions of directive 2006/42/EC.
The product also complies with the following standards:
EN 60335-1:2012+A11:2014, EN 62233:2008, EN 60335-2-103:2015
Oderzo, 21/12/2017
ANNEX 1
Rev: 1
NICE s.p.a.
Via Pezza Alta 13, 31046 Z.I. Rustignè, Oderzo (TV) Italia
Nice s.p.a.
Gearmotor 24Vdc assembled, with incorporated control unit and receiver
AVIO500C, AVIO600C, AVIO1000C, AVIO500CC
Refer to the catalog
Ing. Roberto Griffa
(Amministratore Delegato)
English – 25