Memorisation Of Radio Transmitters; Memorisation Mode - Nice MhouseKit GD1N Instructions Et Avertissements Pour L'installation Et L'utilisation

82
Photocell
Internal photocell h= 50 cm;
A
activated when closing
Internal photocell h= 100 cm;
B
activated when closing
External photocell h= 50 cm;
C
activated when closing and
opening
External photocell h= 100 cm;
D
activated when closing and
opening
WARNING: in the GD1N version the ECSBus output has a maximum load of 1 unit (with A type addresses only).
in the GD10N version it has a maximum load of 6 units; a pair of photocells absorbs power equal to 1 ECSBUS unit.
5.4 – MEMORISATION OF RADIO TRANSMITTERS
The control unit contains a radio receiver for TX4 transmitters; the one
included in the package is pre-memorised and operative.
If you wish to memorise a new radio transmitter you have two choices:
• Mode 1: in this "mode" the radio transmitter is used to its fullest extent,
i.e. all the buttons execute a pre-established command (the transmitter
supplied with GD is memorised in Mode 1). It is obvious that in Mode 1 a
radio transmitter can be used to command a single automation, i.e.:
Button T1 "OPEN" command
Button T2 "Open partially" command
Button T3 "Open only" command
Button T4 "Close only" command
• Mode 2: one of the four commands available can be associated to
each button. This mode, used properly, allows you to command 2 or
more different automations; for example:
Button T1 "Open only" command automation N° 1
Button T2 "Close only" command automation N° 1
Button T3 "OPEN" command automation N° 2
Button T4 "OPEN" command automation N° 3
Obviously, each transmitter is a separate unit, and while some are memo-
rised in mode 1 others can be memorised in mode 2 on the control unit.
The overall memory capacity is 150 units; memorisation in mode 1 takes
up one unit for each transmitter while mode 2 takes up one unit for each
button.
Warning: since the memorisation procedures are timed (10s), you
must read the instructions in the following paragraphs before you
proceed with their execution.
83
TABLE 12
Jumpers Photocell
E
F
G
5.4.1 – Memorisation mode 1
1 Press button P1 [B] for at least 3s.
When the P1 LED [A] illuminates, release the button.
2 Within 10s, press any button on the radio transmitter to be memorised
and hold it down for at least 3s.
If the memorisation procedure is successful, the "P1" LED will flash 3
times.
3 If there are other transmitters to be memorised, repeat step 2 within the
next 10s, otherwise the memorisation stage will terminate automatically.
5.4.2 – Memorisation mode 2
With the memorisation in mode 2 of the radio transmitter, any one of the
four commands ( "OPEN", "Partial opening", "Open only" and "Close
only") can be associated to each button.
In Mode 2 each button requires a separate memorisation stage.
1 Press button P1 (figure 84) on the control unit as many times as the
number corresponding to the desired command, according to the follow-
ing table:
84
External photocell activated
when opening
Internal photocell activated
when opening
INADMISSIBLE
CONFIGURATION
B
Jumpers
A
English – 23