Recognition Of Connected Devices; Recognition Of The Door's Open And Closed Positions; Testing The Radio Transmitter - Nice MhouseKit GD1N Instructions Et Avertissements Pour L'installation Et L'utilisation

3 If the system is equipped with the KS100 key-operated selector switch,
make sure that the night light [C] is on.
70
4 If the above conditions are not satisfied, you should immediately switch
off the power supply to the control unit and check the cable connec-
tions more carefully. For more useful information see also chapters 5.5
"Troubleshooting" and 5.6 "Diagnostics and Signals".
3.5.1 – Recognition of the connected devices
When you have completed the initial checks, the control unit must recog-
nise the devices connected to it on the "ECSBus" and "STOP" terminals.
1 On the control unit, press the P2 button [C] and hold it down for at least
three seconds, then release the button (Figure 71).
2 Wait a few seconds for the control unit to finish recognising the devices.
3 When the recognition procedure is completed, the STOP LED [A] must
remain on, while the P2 LED [B] must go off. If the P2 LED flashes it
means that an error has occurred: see paragraph 5.5 "Troubleshooting".
The connected devices recognition stage can be repeated again at any
time, even after the installation (for example, if an additional photocell is
installed); just repeat the procedure starting from step 1.
71
A
B
3.5.2 – Recognition of the door's open and closed positions
After recognising the devices, the control unit must recognise the door's
open and closed positions. During this stage, the stroke of the door from
the closing stop to the opening stop is detected.
1 Make sure that the carriage is attached.
2 Press key P3 [A] on the control unit and hold it down for at least three
seconds, then release the key (Figure 72).
72
B
• Wait until the control unit has completed the recognition stage: closing,
opening and re-closing of the door.
18 – English
• If any device is triggered during the recognition stage, or the P3 key is
pressed, the recognition stage will be immediately interrupted. In this case
it must be repeated from the beginning.
• During the recognition stage the courtesy light will flash just like the
flashing light.
3 If the P3 LED [B] flashes at the end of the learning stage, it means that
there is an error; see paragraph 5.5 "Troubleshooting".
4 Press the yellow button [C] in figure 73 to execute a complete opening
and closing manoeuvre. Then push it again to perform a complete closing
manoeuvre. During these two manoeuvres the control unit memorises the
force needed at each point along the stroke.
73
It is important that these two first manoeuvres are not interrupted by any
commands.
If the manoeuvres are not completed, repeat the recognition procedure
starting from step 1.
The position recognition stage can be repeated at any time in the future
(for instance, if one of the mechanical stops is moved); just repeat starting
from step 1.
WARNING: if the belt is not tightened properly, during the
C
search for the positions it may slip between the belt and the
pinion. If this happens, stop the learning procedure by pressing
key P3 and stretch the belt by tightening the nut [D]. Then repeat
the recognition procedure starting from step 1.
74
3.5.3 – Testing the radio transmitter
To test the transmitter just press one of its 4 keys, make sure that the red
LED flashes and that the automation carries out the related command.
A
The command associated to each button depends on how it has been
memorised (see paragraph 5.4 "Memorisation of radio transmitters"). The
transmitter supplied has already been memorised and when you press
the buttons the following commands are transmitted:
Button T1
Button T2
Button T3
Button T4
"OPEN" command
"Open partially" command
"Open only" command
"Close only" command
C
D