Operating Guide I; Safety Regulations; Door Control; Maintenance Operations To Be Performed By The User - Nice MhouseKit GD1N Instructions Et Avertissements Pour L'installation Et L'utilisation

STEP 7
This guide should be stored in an accessible location and made available
to all users of the automation.
7.1.1 – Safety regulations
• Keep an eye on the moving door and keep at a safe distance
until the door has completely opened or closed; do not cross the
opening until the door has completely opened and stopped.
• Do not allow children to play near the door or with its controls.
• Keep the transmitters out of the reach of children.
• Stop using the automation system immediately if you notice
anything abnormal (strange noise or jerky movements); failure to
observe this warning may result in serious danger and accidents.
• Do not touch any components while they are moving.
• Have periodic checks made according to the instructions pro-
vided in the maintenance schedule.
• Maintenance operations and repairs can only be performed by
qualified technicians.
7.1.2 – Door Control
With radio transmitter
The radio transmitter is ready for use and the four buttons have the fol-
lowing functions:
T2
T1
Function(*)
Button T1
Button T2
Button T3
Button T4
(*) This table must be prepared by the person who has programmed the
system.
With selector switch (optional accessory)
The selector switch has two positions, with automatic return to the centre.
OPERATING GUIDE
(*) This item must be drafted by the person who has programmed the
system.
Control with safety devices out of order
If the safety devices are out of order or malfunctioning, it is still possible
to control the door.
1 Operate the gate control device (remote control or key-operated selec-
tor switch). If the safety devices enable the operation, the door will open
normally, otherwise: actuate the control again within 3 seconds and keep
it actuated.
2 After approximately 2s the gate will start moving in the "man present"
mode, i.e. so long as the control is maintained the gate will keep moving;
as soon as the control is released the door will stop.
If the safety devices are out of service, the automation must be repaired
as soon as possible.
Gearmotor release
The gearmotor is equipped with a mechanical system which allows the
door to be opened and closed manually (i.e. as if GD were not present)
The manual operation must be resorted to in case of power failures or
system malfunctions.
1 Pull the release cord until you hear the carriage being released.
2 At this point you can move the door manually
3 To restore the functionality of the automation system, move the door
back in position until you hear the carriage being engaged.
The activation of the manual release may cause an uncontrollable
movement of the door if the springs are weak or broken, or if the
T4
door is off-balance.
T3
7.1.3 – Maintenance Operations to be performed by the User
The operations that must be periodically performed by the user are listed
below.
• Use a slightly damp cloth (not wet) to clean the surface of the
devices. Do not use any substances containing alcohol, benzene,
diluents or other flammable substances. The use of these sub-
stances could damage the devices, start fires or generate electric
shocks.
• Disconnect the power supply to the automation before you
proceed to remove leaves and debris, to prevent anyone from
activating the door.
Action Function
Rotated to the right: "OPEN" (*)
Rotated to the left: "STOP" It stops the movement of the
sectional or overhead door
English – I