Honeywell IAQPoint2 Guide De Démarrage Rapide page 954

COM Menu
This screen displays the selected communication protocol for device
addresses from 1 to 96. Each transmitter's protocol is defined by the
controller (see Network Auto-configuration section)
.
If a transmitter is compatible with several different protocols, it can be
modified using to one of the following options:
• Vulbus
• Mdbs ASCII 7D 2S NP 9600 bauds
• Mdbs RTU 8D 2S NP 9600 bauds
• Mdbs RTU 8D 1S NP 9600 bauds
• Mdbs RTU 8D 1S OP 9600 bauds
When a transmitter is configured with the Modbus communication
protocol, the transmitters automatically sends the programmable
parameters to the controller.
Note: Vulbus transmitter parameters must be programmed manually.
M-511401
8/10
1. Tx Info 1. Tx Info
-COM- -COM-
Mdbs RTU 8D 1S EP Mdbs RTU 8D 1S EP
9600 bauds 9600 bauds
96d User Manual
Honeywell
System Programming
001 001
Tx Info Menu
27