Honeywell IAQPoint2 Guide De Démarrage Rapide page 509

System Programming
Wireless Network Menu
The following table provides the list of parameters displayed for the
coordinator (wireless communication module). Use the up or down
keypad arrows to navigate the entire list.
# Title
1. 7B177A7EFACE0049
2. WC Version
3. PAN ID
4. RF channel
5. Log Mode
6. Association
7. Nodes
8. Max nodes
9. Max hops
10. Power
11. AHFO
12. BO
13. SUO
14. LCO
15. LTO
80
Value
Coordinator MAC address
A10 Wireless coordinator firmware version
FF07 The hexadecimal ID number assigned
to the coordinator
11 Radio frequency channel
No Displays whether debug mode is
Log activated
Ina Defines whether new nodes can join the
network
0 Displays the number of nodes
associated to the wireless coordinator.
0 Defines the maximum nodes that can
reside in the network (1-60)
0 Defines the maximum number of hops a
node can make on a communication
route to the wireless coordinator
0 Sets the transmission power amplifier
value
0 Defines the time between wake-up
cycles
0 Sets the time between transmission of
two consecutive beacons by a node to
establish and maintain synchronization
0 Defines the status update period; time
between 2 consecutive status update
packets sent from node to coordinator
18 Packet sent from the coordinator to the
node, confirming to the node that it is
registered on the network at the
coordinator
0 The number of status update packets
that can be missed before a "leave
indication" is triggered
301C User Manual
Honeywell
Description
M-510324
7/10