Honeywell IAQPoint2 Guide De Démarrage Rapide page 945

The controller units are customized to the purchaser's specifications but
they can be further programmed using the following menu options.
Initial Startup
Make sure that all wiring has been completed according to
specifications in the wiring details before powering up the unit. When
all is secure, remove the SHDN jumper to power-up the unit. It should
only take a few seconds until the unit is fully operative.
Datalogger (SDcard)
The DLC (Data Logger Card) option for the controller collects data and
stores it on a digital Flash memory card (SDCard). In the event that the
card memory becomes full:
• Information logging is stopped
• No SDcard flag is displayed on-screen
• The SDcard LED blinks
See the Acquisition section for more details on starting and stopping the
datalogging function.
Always deactivate datalogging function before removing the
CAUTION
SDcard. Never remove the card when its LED is on.
M-511401
8/10
Getting Started
96d User Manual
Honeywell
Getting Started
Relay Output
17